Caution 3>>Precaution related handling the machine.
If you ignore this information, you could get harm and machine could be damaged.
(1) Do not install it on the different levels, or slanted floor.
Please confirm whether it is balanced or not after installation. If it is unbalanced, an accident can be happened due to
the machine fell over.
(2) Be careful not to insert a finger or hair in the rotating unit.
Be careful not to insert a finger of hair in the rotating unit (motor, fan, paper feeding part, etc) while the machine is
operating. Once it happens, you could harm.
(3) Do not place a pot contains water/chemical or small metals. If those are got into the inner side of machine, a fire or
electric shock can be occurred.
(4) Do not install it in where lots of moisture or dust exists or where raindrop reaches. A fire or electric shock can be
caused.
(5) Do not place a candlelight, burning cigarette, and etc. on the machine. Do not install it near to heater. A fire can be
occurred.
Caution 4>>Precaution when assembly/disassembly
When replace parts, do it very carefully. Do memorize the location of each cable before replace parts for reconnecting it
afterwards. Do memorize. Please perform the below before replace or disassembly the parts.
(1) Check the contents stored in the memory. All the information will be erased after replace main board. The information
needed to keep has to be written down.
(2) Before servicing or replacing electric parts, take off a plug.
(3) Take off MFP cables and power code connected to MFP.
(4) Do use formal parts and same standardized goods when replacing parts.Must check the product name, part code,
rated voltage, rated current, operating temperature, etc.
(5) Do not give an over-force when release or tighten up the plastic parts.
(6) Be careful not to drop the small parts such as screws in the MFP.
(7) Be careful not to change the location of small parts such as screws when assembling and disassembling.
(8) Do remove dust or foreign matters completely to prevent fire of tracking, short, or etc.
(9) After finished repair, check the assembling state whether it is same as before the repair or not.
Precautions
Samsung Electronics 1-3
To Next Page
Loading...
Need help?
General
