Disassembly and Reassembly
Service Manual
3-9
Samsung Electronics
3.2.5 Middle Cover
3.2.6 Fuser
1. Remove the 2 screws as shown below. 2. Remove the 2 screws from the front and rear of
the SET. Unplug the harness connected to the
main board. And lift the middle cover up.
1. Remove the rear cover. Remove the Guide rear
by pushing both side and removing the hinge.
2. Remove the 4 screw. And remove the fuser after
remove the connector.
CAUTION
The fuser is very hot. So turn the printer off
and wait until the printer to cool before
replacing it.
To Next Page
Loading...
