Disassembly and Reassembly
Samsung Electronics
No Parts Procedure Remark
2
3
4
AssÕy Tray Drain.
Electrical Parts
(Main PCB)
Heat Exchanger
1) Do Ò1Ó above.
Separate the drain hose from the extension
drain hose.
2) Take the display PCB out.
(Right of indoor unit)
3) Pull tray drain out from the back body.
1) Do Ò1Ó, Ò2Ó above
2) Take all the connector of PCB upper side out.
(Inclusion Earth Wire)
3) Separate the outdoor unit connection wire
from the terminal block.
4) If pulling the Main PCB up. it will be taken
out.
1) Do Ò1Ó and Ò2Ó, Ò3Ó above
2) Loosen two fixing earth screws of right side.
3) Separate the connection pipe.
4) Separate the bush body at the upper side and
holder at the rearside.
5) Loosen the two fixing screws of left side.
6) Lifting the heat exchanger up a little to push
the up side for separation from the indoor
unit.
4-2
6-00115A(5)-DA 3/8/01 10:36 AM Page 4-2
To Next Page
Loading...
