Samsung Electronics
5-9
Troubleshooting
! If the first number is , it is correct otherwise press until
appear.
@ When pressing the button ~ appear on the display,
select one of them.
# When pressing the button ~ appear on the display,
select one of them.
$ When pressing the button ~ appear on the display,
select one of them.
% When pressing the button ~ appear on the display,
select one of them.
^ When pressing the button ~ appear on the display,
select one of them.
Step 3 : Reconfirming option set after completion
(in case of ex. 017d25-17021d)
After pressing selector for the mode, the display shown as .
After pressing selector for the mode, the display shown as .
Step 4 : Pressing the ON/OFF button ( )
When pressing the operation ON/OFF key with the direction of remote controller for unit,
the sound ÒDingÓ or ÒDiriringÓ is heard and the first LED lamp on the left side is flicker-
ing at the same time, then the input of option is completed. (If the diriring sound isnÕt
heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
¥ Error Mode
1
st
If all lamps of indoor unit are flickering, Plug out and plug in again and pressing ON/OFF key to retry.
2
nd
If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if
the correct option code is set up for itÕs model.
9-00115A(3)-TS 3/19/01 2:39 PM Page 5-9
To Next Page
Loading...
