Samsung SH24TP6 A - 3-2 Outdoor Unit

Disassembly and Reassembly
Samsung Electronics3-2
No Parts Procedure Remark
2
3
4
Electrical Parts
(Main PCB)
Ass’y Tray Drain.
Heat Exchanger
1) Do “1”, above.
2) Take all the connector of PCB upper side out.
(Including Power cord)
3) Separate the outdoor unit connection wire
from the terminal block.
4) If pulling the Main PCB up. It will be taken
out.
1) Do “1”, “2”, above.
2) Separate the drain hose from the extension
drain hose.
3) Pull tray drain out from the back body.
1) Do “1”, “2”, “3”, above.
2) Loosen 2 fixing earth screws of right side.
3) Separate the connection pipe.
4) Separate the holder pipe at the rear side.
5) Loosen 3 fixing screws of right and left side.
6) Separate the heat exchanger from the
indoor unit.
DB98_13339(A)_1~40 03/5/16 1:59 PM Page 3-2