English - 1
Connection Panel (depending on the model)
☛
Whenever you connect an audio or video system to your
television, ensure that all elements are switched off.
Please be sure to match the color coded input terminals
and cable jacks.
Connecting to an Aerial or Cable Television Network
Connect the aerial or network input cable to the
1
(75 Ω
coaxial socket).
To view television channels correctly, a signal must be
received by the set from one of the sources: an outdoor
aerial, cable television network, or satellite network.
If you are using an indoor aerial, you may need to adjust it
when tuning your television until you obtain a picture that is
both sharp and clear.
Rear Panel
☛
Please be sure to match the colour coded input terminals
and cable jacks.
Connecting to the RCA Input
The
3
(AUDIO-L/R) and 2 (VIDEO) connectors are used
for equipment, such as a camcorder, video disc player, or
video game device.
Connecting to the S-Video Input
The 1 (S-VIDEO input) and 2 (VIDEO input) connectors
are used for equipment with an S-Video output, such as a
camcorder or VCR.
➢
When both the front (or side) AV and rear connectors are
connected to external equipment, the front (or side) AV
receives priority.
COLOUR TELEVISION
CS29Z40 / CS29Z45 / CS29Z47 / CS29Z50 /
CS29Z57 / CS29Z58 / CS29A730 /
CS29A760
/ CS29A750
Owner’s Instructions
Before operating, please read this manual thoroughly,
and retain it for future reference.
Register your product at
www.samsung.com/global/register
➢
The actual configuration of your TV may be different,
depending on your model.
Control Panel (depending on the model)
You can use the 3 buttons to switch the TV on when it is
in standby mode depending on the model.
The 2 and 3 buttons also have the same function as
the ◄/►/▲/▼ buttons on the remote control.
If the remote control no longer works or you have
misplaced it, you can use the controls on the panel of the
television.
Front (or Side) Panel
1
On-screen menu display
2
Volume adjustment
3
Channel selection
4
Remote control sensor
5
Standby indicator
6
Power on/off
AA68-004001A-00
1 S-Video input
2 Video input
3 Audio input
Front (or Side) Panel
➢
The actual configuration of your TV may be different,
depending on your model.
Connecting to the RCA Output
The RCA
2
connectors are used for equipment, such as a
recording VCR or audio system.
Connecting to the RCA Input
The RCA
3
and RCA
4
connectors are used for equipment,
such as a VCR, DVD, decoder, satellite receiver, video
game device, or video disc player. (When using the mono
equipment, connect to the
AUDIO-L input connector.)
The RCA
5
connectors are used for equipment such as a
DVD with component output (480i only).
cable television
network
or
cable television
network
or
To Next Page
Need help?
General
