Samsung SMT-i5220 User Manual

Samsung SMT-i5220 Setup Guide
Hardware Setup and Connections
Initialising
Initially the SMT-i5220 handset will need to be setup to operate within the users network. The Setup Menu is also used to
make changes to the handset, in the event that the system information should change. The current selected option is
highlighted when viewing the menus.
The station number will be assigned automatically once the necessary information has been entered into the handset.
Enter the ID and password of the server as described below to resister the station.
See your system administrator for specific network and server addresses. The addresses necessary to set up the SMT-
i5220 are:
 IP Address of station
 Network Gateway Address
 IP Address of main telephone system
 Userid
 {password

Samsung SMT-i5220 Specifications

General

Device Type	IP Phone
Display	LCD
Network Interface	10/100 Mbps Ethernet
Ethernet Ports	2
Power over Ethernet	Yes
Audio Codec	G.711, G.729
Power Supply	PoE
Supported Protocols	SIP

Summary

Hardware Setup and Connections

Initialising

Setup Mode

Describes the procedure to enter and navigate the setup menu for initial configuration.

Easy Install

Guides users through network parameter configuration for initial setup.

Phone Information

Displays version information for boot ROM, software, DSP, and hardware.

Network

Details network settings like Static IP, Dynamic IP, PPPoE, NAT, 802.1x, VLAN.

Server

Configures primary system IP and up to four additional server IPs.

Extension Login

Allows phone to register on power-up or login/logout from idle mode.

S/W Upgrade

Specifies TFTP server for software upgrades and initiates the process.

Factory Reset

Returns the handset to its original factory default settings.

Phone Restart

Reboots the handset.