Why can't I connect to Samsung SND-5080 Security Camera using Internet Explorer 7.0 tab browser?
When connecting to the Samsung Security Camera system using a tab browser, the same cookie information is shared, which can cause connection errors. Instead of using a tab browser, open a new browser window to connect to the system.
Why can't I format the SD memory card in my Samsung Security Camera?
If you cannot format the SD memory card in your Samsung Security Camera, check if the write protection tab of the memory card is set to “LOCK.”
Why doesn't SD memory indicator turn on for Samsung SND-5080 Security Camera?
If the SD memory indicator does not turn on even when the SD memory card is inserted into your Samsung Security Camera, check if the memory card is defective. Also, check if the is checked in the ? ? menu.
What to do if Samsung SND-5080 Security Camera does not operate properly with SD memory card?
If your Samsung Security Camera isn't operating properly with an SD memory card inserted, first, check if the memory card is inserted in the correct direction. If it is, and the card was formatted by another device, format the memory card again using the camera's ? ? menu.
Why do images overlap on my Samsung Security Camera?
If images from your Samsung Security Camera are overlapping, it might be because multiple cameras are set to a single multicast address. Check to ensure that each camera uses a different multicast address.
Why is no JPEG file transferred via e-mail from Samsung SND-5080?
If your Samsung Security Camera isn't transferring JPEG files via email during an intelligent video analysis event, even when Intelligent Video Analysis is enabled, verify the settings in this order: A. Check the Data & Time settings. B. Ensure Intelligent Video Analysis is set to Enable. C. Alarm Video Transmission must be enabled.
Why does my Samsung SND-5080 viewer disconnect during monitoring?
If the viewer gets disconnected during monitoring with your Samsung Security Camera, it might be due to changes in the camera or network configurations; check all network connections. Also, if the camera is connected over a PPPoE network, poor network conditions could cause disconnections.
What to do if Samsung Security Camera is not detected in the IP installer program?
If your Samsung Security Camera connected to the network isn't detected by the IP installer program, try turning off the firewall settings on your PC and then search for the camera again.
Why Samsung SND-5080 cannot record into the SD memory card?
If you cannot record onto the SD memory card with your Samsung Security Camera, first check if the memory card is defective. Also, check if the write protection tab on the memory card is set to “LOCK.”
How to fix Samsung SND-5080 Security Camera when I can’t access it from a web browser?
General| Frame Rate | 30fps |
|---|---|
| Type | Dome |
| Compression | H.264 |
| Audio Support | No |
| Operating Temperature | -10°C |
Critical safety guidelines and warnings for operating the camera. Essential for safe usage.
Step-by-step instructions for mounting and installing various camera models.
Guide on inserting and removing SD memory cards for recording and storage.
Methods for connecting the camera to local area networks and modems.
Guidance on setting static and dynamic IP addresses using the IP Installer.
Setup instructions for configuring port range forwarding on routers for remote access.
To Next Page
