2120
Channel Add/Delete
Use this feature if Auto Channel Search missed a channel that you
would like to add, or added a channel you wish to remove.
1 Open “SETUP MENU”
With the DVD in stop mode, press the SETUP button.
2 Select “Install”
Using the up/down and left/right buttons, move the selection cursor
to “Installation”, then press ENTER to select.
3 Select “Channel Setup”
Using the up/down buttons, move the selection cursor to “Channel
setup”, then press ENTER to select.
4 Select “Channel add/delete”
Move the selection bar to “Channel add/delete,” then press ENTER
to select.
5 Select Channel to add/delete
Use the CH
/
❷
buttons to tune in the channel number you wish
to add or remove.
6 Select “CHANNEL ADD/DELETE”
Press right to add or press left to remove the channel from
your channel list.
• Repeat steps 4 and 5 to add or remove additional channels.
Auto Channel Memory will automatically seek and store all active
channels in your area.
1 Open “SETUP MENU”
With the DVD in stop mode, press the SETUP button.
2 Select “Install”
Using the up/down and left/right buttons, move the selection cursor
to “Installation”, then press ENTER to select.
3 Select “Channel Setup”
Using the up/down buttons, move the selection cursor to “Channel
setup”, then press ENTER to select.
4 Run “Auto channel memory”
Move the selection arrow to “Auto channel memory,” then press
ENTER to select.
• The DVD-VCR will automatically search for all available
channels in the selected Tuner Band. This procedure may take
a few minutes to complete.
• When finished, the lowest channel found will be displayed.
Auto Channel Memory
To Next Page
Loading...
