Phone Basics 16
Phone Basics
1. Make sure your phone is on.
2. Enter a phone number. (If you make a mistake while dialing,
press to erase one digit at a time. Press and hold to
erase the entire number.)
3. Press to call.
4. Press or close the phone when you are finished.
Tip: To redial your last recent call, press twice.
Tip: Some networks support + dialing. + dialing automatically
indicates to the network that you are dialing an international call and
adds the international dialing prefix (typically ‘011’) to the call
automatically. To use + dialing, press and hold (until the +
appears) before entering the phone number.
You can also place calls from your phone by using Voice Command
(page 38), Speed Dialing numbers from your Contacts (page 22), and
using your Call History listings (page 63).
Answering Calls
To answer an incoming call:
1. Make sure your phone is on. (If your phone is off, incoming
calls go to Voicemail.)
2. Press to answer an incoming call. (Depending on your
phone’s settings, you may also answer incoming calls by
opening the phone or by pressing any number key. See “Call
Answer Mode” on page 146 for more information.)
Your phone notifies you of incoming calls in the following ways:
• The phone rings or vibrates (unless set to Silence All).
A900 BMC.book Page 16 Monday, May 22, 2006 9:50 AM
To Next Page
Loading...
