12
O Powerbutton
Turns the PDP on and off.
0 Numberbuttons
0 Displaybutton
Press to display information on the PDP screen
0 Menubutton
Displays the main on-screen menu.
0 CH(Channel)andVOL(Volume)buttons
Channel and Volume buttons are used for selecting
-nenu items in menu mode.
0 Mute button
Press to mute the PDP sound.
0 P.Modebutton
Adjust the PDP picture by selecting one of the preset
factory settings (or select your personal customized
picture settings.)
0 Aspectbutton
Press to change the screen size.
0 Modebutton
Selects a target device to be controlled by the Sam-
sung remote control (ie., VCR. Cable. or DVD players).
_) ClockDisplaybutton
Press to display clock on the PDP screen
• Sourcebutton
Press to display all of the available video sources
lie., Video. S-Video. Component1. Component2
PC(RGB)).
Joystickbutton
Use to highlight on-screen menu items and change
"nenu values.
I_) Stillbutton
Press to pause the current screen.
_) PIP button
Acuva[es picture in picture.
I_) Sourceselectionbuttons
Press to directly select Video. S-Video. Component1.
Component2 or PC(RGB).
O
@
@
0
0
0
0
0
0
@
Q
0
®
@
@
I_) VCRcontrolbuttons
Controls VCR tape functions: Stop, Rewind,
Play/Pause, Fast Forward.
_SET button
Used during setup of this remote control, so that it will
work compatibly with other devices (VCR, cable box,
I_) Clockset button
Press to set clock.
Source : Press to select one of the available signal
sources for the PIP window.
S.Sel : Press to select the Audio (PiP or Main).
Locate : Press to move the PIP window to any on the
screen.
_) PCcontrolbuttons
AutoAdjus,
Scaling
Zoom/Pan
_) S.Modebutton
AdJust the PDP sound by selecting one of the preset
factory settings (or select your personal, customized
sound settings.)
I'_,)Sleepbutt0n
Press to select a preset time interval for automatic
shutoff.
1 Slide the back cover i 2 ,osta,, two HA Size batter-i 3Slidethe cover back into
to open the battery i ies. Make sure to match the i place.
compartment of the i "÷' and "-:' ends of the bat- i
remote control ! teries with the diagram i
i inside the compartment, i
! :
RemoteControlOperationRange.
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the remote control receiver of the monitor.
13
To Next Page
Loading...
