14
@ InstallationNotes
1
2
3
Do not install the PDP in any location other than vertical walls.
To protect the performance of the PDP and prevent problems avoid the following
31aces.
• Do not install next to smoke and fire detectors
• Do not install in an area subjected to vibration.
• Do not install in an area subjected to high voltage.
• Do not install near or around any heating apparatus.
Use only recommendeG parts and components.
0 Pairs (Wallattachmentpanelissoldseparately.Checkwithyourdealer)
Wall attachmentpanel
34.61 inches
bolt Insulation holder
O InstallingtheDisplay0ntheWallAttachmentPand
"1 See the drawing of the wall attachment panel shown in page 14 to check for
| the Stability Of the wall where the PDP is to be installed. If the wall is not
enough strong to support the PDP, strengthen the wall before installation.
ii !_ _
ii i iii iiiiii
iiii iiii
When the angle When the angle When the panel
has been set to 5 has been set to hasn't been tilted,
degrees, degrees.
10
¸¸¸¸¸¸¸¸15
20 degrees of tilt
15
To Next Page
Loading...
