Samsung SyncMaster 1200NF

English 21
Adjusting Your Monitor
D-SUB/BNC
Use this menu to choose between the signal source
connected to the BNC connector input and the
signal source connected to the D-SUB connector
input.
1
With the menu off, push the button.
Push the button or button until the
“Advanced” screen is displayed.
2
Push the button or button to select
D-SUB/BNC.
3
Push the button to open the D-SUB/
BNC selection screen.
4
Use the button or button to select
D-SUB or BNC .
NOTE: When you are finished, wait for a few
seconds and the screen will blank then
display the image from the new signal
source (Other computer). A cable must be
connected to both inputs to use this
function.
USB
Use this menu to choose between the up stream
ports A or B.
1
With the menu off, push the button.
Push the button or button until the
“Advanced” screen is displayed.
2
Push the button or button to select
USB.
3
Push the button to open the USB
selection screen.
4
Use the button or button to select
A or B .
:
RGB
+++
G
Degauss
Reset
Sync. Input Type
Video Input Level
D-SUB/BNC
USB
Advanced
Access Function
:
D-SUB BNC
D-SUB/BNC
Previous Menu
:
RGB
+++
G
Degauss
Reset
Sync. Input Type
Video Input Level
D-SUB/BNC
USB
Access Function
Advanced
:
USB
A B
Previous Menu
12NF(E)body.fm Page 21 Thursday, October 19, 2000 5:44 PM