Miniature jack AC Cord Inlet D-Sub Cable
his section of the User’s Manual
explains how to connect the Color
Monitor to IBM or PC-compatible
computers, as well as Apple Macintosh
computers.
Note : Miniature jack
Do not plug anything into the miniature
jack on the rear of the monitor This inter-
face is for factory adjustments and certi-
fied service center use only. Unauthorized
use of this connector will cause damage to
the monitor.
Connection to Your Computer -
IBM or PC-Compatible
Your Color Monitor complements a wide
range of IBM and PC-compatible systems.
To attach the monitor to this type of sys-
tem, follow these instructions
1.
Turn off the power to the monitor and
computer.
2.
Connect the 15-pin end of the signal
cable to the video connector on your
computer’s video controller. Tighten
the screws of the signal cable to
ensure proper connection.
Note: Your computer system has one of
two configurations:
l The video controller is built into the
computer.
l The video controller is in the form of a
display adapter ( also referred to as a
video card, graphics card, graphics
board, or graphics adapter ).
5
ENGLISH
To Next Page
Loading...
