Main Icons Select Button
Remocon Info Grid
Safety Lock Display Selection
Port Selection Control Tools
1. Use the main icons to switch to each screen.
2. Enables/Disables the remote control signal receiving function of the display unit.
3. The setting for the PC Serial Port can be changed. The original value is COM1.
4. Sets the Lock Function.
5. Click Select all or Clear to select or clear all displays.
6. Use Grid to view brief information on the selected display.
7. Select a display in Display Selection.
8. Use the Control Tools to control the displays.
The remote control Enable/Disable function operates regardless of whether the power is
On/Off, and this applies to all displays connected via the MDC. However, regardless of the
status at the time the MDC is shut down, the remote control signal receiving function of all
displays is initialized to Enable when the MDC is closed.
2. Beginning - Port Selection
To Next Page
Loading...
