Specification
1. Each value should be gradually set in "Delay Touch Settings" after fulfillment of "Enable
Delay Touch". "Delay" is set to 40 and "Area" to 16.
2. Enter count : It means how many times you click to approach the setting value within 3
seconds. Then driver will install the function of "False touch rejection" where quick click
or scratch will be considered void except the touch point on the active area for quite a
while.
3. Leave count : "False touch rejection" is no longer effective when the click times within 5
seconds is less than the setting number.
Using the Software
To Next Page
Loading...
