Main > Setup > Connecting Your Monitor
Connecting
Your Monitor
Installing the
Monitor Driver
Base Installation
1. Setup-General | 2. Setup-For Multimedia model | 3. Multimedia Speaker Stand
1. Setup-General
1. Connect the power cord for your monitor to the power port on the back of the monitor.
Plug the power cord for the monitor into a nearby outlet.
2. Connecting the signal cables.
1) Connecting to the PC.
(Connect the signal cable to the 15-pin D-sub connector on the back of your monitor. Connect
the signal cable to the video port on your computer, video board, video card, or graphics card.)
2) Connecting to old Macintosh models
If you are using a Macintosh computer, connect the cable to a Macintosh adapter, and set the
pins on your adapter(Adapter not included). A PC-compatible computer does not need an
adapter.
3) When you use a BNC connector.
Connect the signal cable to the BNC signal port on the back of your monitor/computer.
3. Connect the USB cable to the USB port on the back of your monitor/computer.
(You need it to use the MouScreen program.)
4. Turn on your computer and monitor. If your monitor displays an image, installation is complete.
2. Setup-For Multimedia model
SyncMaster 957MB
To Next Page
Loading...
