Samsung SyncMaster 950p - Page 22

20
Adjusting Your Monitor
D-SUB/BNC
Use this menu to choose between the signal source
connected to the BNC connector input and the
signal source connected to the D-SUB connector
input.
1
With the menu off, push the button.
Push the button or button until the
Advanced screen is displayed.
2
Push the button or button to select
D-SUB/BNC.
3
Push the button to open the D-SUB/
BNC selection screen.
4
Use the button or button to select
D-SUB
or
BNC
.
NOTE: When you are finished, wait for a few
seconds and the screen will blank then
display the image from the new signal
source (Other computer). A cable must be
connected to both inputs to use this
function.
Menu Position
You can change the position where the OSD menu
appears on your monitor.
1
With the menu off, push the button.
Push the button or button until the
Menu screen is displayed.
2
Push the button or button to select
Menu Position
.
3
Push the button to open the menu
position adjustment screen.
4
Use the , , or button to place
the menu in the position you prefer.
RGB
:
+++
G
Advanced
Degauss
Recall
Sync. Input Type
Video Input Level
D-SUB/BNC
Access Function
:
D-SUB/BNC
D-SUB BNC
Previous Menu
RGB
:
Menu
Menu Position
Menu Duration
Languages
Access Function
:
2
8
Menu Position
Previous Menu
950pe.book Page 20 Monday, November 22, 1999 2:55 PM