57
Setup and Reset
6
6 Setup and Reset
Configuring Backlight
1 Press [ ] on the product.
2 Press [ ] to move to SETUP&RESET and press [ ] on the product.
3 Press [ ] to move to ECO and press [ ] on the product.
4 Press [ ] to move to Backlight and press [ ] on the product. The following screen will
appear.
z Off: Turn off the screen and activate DPMS mode. If Off is selected, it takes several seconds for
the monitor to detect movement and turn on after it turned off.
z Dimming: Reduce the brightness of the screen (still turned on).
5 Press [ ] to move to the option you want and press the [ ].
6 The selected option will be applied.
z The performance of Eco Motion Sensor is maximized to a specific user distance (1m) and angle
(40 degrees).
z The sensor may not detect you if you are motionless.
z If you think that the mode entry message appears too frequently, increase the time setting of the
Eco Motion Sensor or turn the Eco Icon Display Off.
z Avoid using radio equipment such as a walkie-talkie near the product as this may cause a product
malfuction.
To Next Page
Loading...
