A: The frequency can be changed by reconfiguring the video card.
Note
That
video card support can vary, depending on the version of the driver used. (Refer to the
computer or the video card manual for details.)
Q: How can I adjust the resolution?
A: Windows XP:
Control Panel → Appearance and Themes → Display → Settings.
A: Windows ME/2000:
Control Panel → Display → Settings.
* Contact the video card manufacturer for details.
A: Windows 7:
Go to Control Panel → Appearance and Personalization→ Display → Adjust Resolution and
adjust the resolution.
Q: How can I set the Power Saving function?
A: Windows XP:
Control Panel → Appearance and Themes → Display → Screen Saver.
Set the function in the BIOS-SETUP of the computer. (Refer to the Windows / Computer Man-
ual).
A: Windows ME/2000:
Control Panel → Display → Screen Saver.
Set the function in the BIOS-SETUP of the computer. (Refer to the Windows / Computer Man-
ual).
A: Windows 7:
Set power-saving mode in Control Panel → Appearance and Personalization→ Personalize →
Screen Saver Settings or BIOS SETUP on the PC.
Q: How can I clean the outer case/LCD Panel?
A: Disconnect the power cord and then clean the LCD Display with a soft cloth, using either a
cleaning solution or plain water.
Do not leave any detergent or scratches on the case. Do not let any water enter the LCD Display.
Q: How can I play the video?
A: The video supports the MPEG1 and WMV codecs only. Install the corresponding codec to play
the video. Note that some of the codecs can be incompatible.
Note
Before
calling for assistance, check the information in this section to see if you can remedy any prob-
lems yourself. If you do need assistance, please call the phone number on the Information section or
contact your dealer.
Troubleshooting
To Next Page
Loading...
