Samsung TA350 - Connections; Connecting to Antenna & Initial Setup

15
English
Connections
Connecting to an Antenna
When the TV is initially powered on, basic settings proceed automatically.
✎ Preset: Connecting the mains and antenna.
Plug & Play (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the
POWER P button. Plug & Play is available only when the Input Source is set to TV.
✎ Before turning on the TV, make sure the antenna cable is connected.
✎ To return to the previous step, press the Red button.
1
Select the OSD Language.
Press the ▲ or ▼ button, then press the ENTER
E button.
Select the desired OSD (On Screen Display) language.
(Not available in some locations)
P
POWER
2
Selecting Store Demo or
Home Use
Press the ◄ or ► button, then press the ENTER E button.
y Select the Home Use mode. Store Demo Mode is for retail
environments.
y To return the unit’s settings from Store Demo to Home Use
(standard): Press the volume button on the TV. When you see the
volume OSD, press and hold MENU for 5 sec.
y Store Demo is only for shop display. If you select it, several
functions are not able to use. Please select Home Use when you
watch at home.
3
Select Country. / Select
Area.
(depending on the country)
Press the ▲ or ▼ button, then press the ENTER
E button. Select the appropriate
country.
4
Set the Clock Mode. Set the Clock Mode automatically or manually.
y Auto: Set the current time automatically using the time from a digital channel.
✎ Allows you to select a time zone. Press the ▲ or ▼ button to highlight the
time zone for your local area. Press the ENTER E button. (depending on
the country)
y Manual: Allows you to manually set the current date and time.
5
Selecting a channel Select the channel source to memorise among Digital & Analogue / Digital /
Analogue. When done, select Search. Scans for a channel automatically and stores
in the TV.
✎ Press the ENTER E button at any time to interrupt the memorisation process.
6
Enjoy your TV. If you want to watch a broadcast program, select OK.
If You Want to Reset This Feature...
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0.” If you want to
change the PIN number, use the Change PIN function.
You should do Plug & Play (MENU → System) again at home although you did in shop.
✎ If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets
the PIN to “0-0-0-0”: POWER (off) → MUTE → 8 → 2 → 4 → POWER (on).
ANT OUT
Connections