◀ ▶
Problem Possible Solution
I want to start Anynet+.
●
Check if the Anynet+ device is properly connected to
the TV and check if the Anynet+ (HDMI-CEC) is set to
On in the System menu.
●
Press the TOOLS button to display the Anynet+ menu
and select a menu you want.
I want to exit Anynet+.
●
Select View TV in the Anynet+ menu.
●
Press the SOURCE button on the TV remote control
and select a device other than Anynet+ devices.
●
Press
>
CH
<
button to change the TV mode. (Note
that the channel button operates only when a tuner-
embedded Anynet+ device is not connected.)
English
To Next Page
Loading...
