Unpack the product and check if all of the following
contents have been included. Store the packaging
box in case you need to move the product at a
later stage.
A 30-second stand-by time is required after turning
the product on.
Package Contents
Installing the stand
Quick Setup Guide
Turn the stand in the direction
indicated by the arrow.
Caution: Do not remove the stopper
pin before completely installing
the stand’s base. Otherwise it may
cause physical injury.
Turn the connecting screw at the
bottom of the stand fully so that it
is completely secured.
After installation of the base is
complete, stand the product up.
• Remove the stopper pin.
• Adjust the height of the screen
to your specications.
Make sure that the stand has
been properly turned in the right
direction.
Push the base into the product’s
stand in the direction indicated by
the arrow.
9K>8VWaZ EdlZg8dgY9"hjW8VWaZ
LVggVcin8VgY
CdiVkV^aVWaZ^cVaaadXVi^dch
JhZgh<j^YZ
Fj^X`HZije<j^YZ
7ViiZg^Zh666M'
CdiVkV^aVWaZ^cVaaadXVi^dch
;Zgg^iZ8dgZ[dgA6CXVWaZ
GZbdiZ8dcigda
HiZgZd8VWaZ 8aZVc^c\8adi]A6C8VWaZ
1
4
2
5
3
6
Before attaching the stand, place a soft cloth on a at, stable surface, and then place the product onto the cloth so that the screen
is facing downwards.
Caution: 1. When placing the product on a at surface, you can damage the projection on the camera.
2. To prevent damage, place the monitor down gently & carefully.
3. Do not remove the stopper pin before installing the base.
BN68-02401C-01
To Next Page
Need help?
General