Troubleshooting
English60
Troubleshooting
Code Meaning
8C
Check the MEMS sensor.
• Power the washer off. Wait 2-3 minutes, power the washer on, and
then try again.
• If the problem continues, call for service.
dn
Firmware update is in progress through SmartThings.
• To use the product, wait about 30 minutes until the rmware
update completes. (The time required to complete the rmware
update may vary depending on your Internet connection.)
• This code will remain on the display, regardless of power on and
off, until the rmware update is complete.
For any codes not listed above, call 1-800-726-7864 (1-800-SAMSUNG).
Untitled-1 60Untitled-1 60 2023-03-31() 11:06:392023-03-31() 11:06:39
To Next Page
Loading...
