30_ maintaining your washer
maintaining your washer
PURE CYCLE
TM
Pure Cycle is a self-cleaning cycle that removes mold that may occur
inside the washing machine.
1. Press the Power button.
2. Select the Pure Cycle
TM
course.
• Once the Pure Cycle
TM
course is selected, the only function
that can be set is Delay Start.
3. Press the Start/Pause button.
• If you press the Start/Pause button, Pure Cycle begins.
• Using Pure Cycle, you can clean the drum without
using a cleansing agent.
• Never use Pure Cycle when laundry is in the washing
machine. This may cause damage to the laundry or a
problem with the washing machine.
The Pure Cycle Auto Indicator Function
• If the “Pure Cycle” is lit after a wash, it indicates that tub (drum) cleaning is required. In this
case, remove the laundry from the washing machine, turn the power on, and clean the drum
by running Pure Cycle.
• If you do not run Pure Cycle, the “Pure Cycle
TM
” indicator turns o. However, the “Pure
Cycle
TM
” indicator will light again after two washes. Not running Pure Cycle at this point will
not cause a problem with the washing machine.
• Although the Pure Cycle Auto Indicator appears once a month or so, the frequency may dier
depending on the number of times the washing machine is used.
WA50F9A7D*
WA50F9A8D*
WA50F9A6D*
CAUTION
F900A WASH_WA50F_USER MANUAL_DC68-03133H_EN.indd 30 2013-1-23 16:48:52
To Next Page
Loading...
Need help?
General