English
Installation
English14
CAUTION
Do not stretch the water hose by force. If the hose is too short, replace the hose with a longer, high-
pressure hose.
Connecting to a non-threaded water tap (applicable models only)
1. Remove the adaptor (A) from the water hose (B).
2. Use a Phillips screwdriver to loosen four screws on
the adaptor.
3. Hold the adaptor and turn part (C) in the arrow
direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap, and then
tighten the screws while lifting the adaptor.
5. Turn part (C) in the arrow direction to tighten it.
Untitled-10 14 2023-06-15 6:31:41
To Next Page
Loading...
