18_installation & maintenance
HOW TO CONNECT THE DRAIN HOSE (OPTION)
IN CASE OF PUMP-DRAINED WASHER
cap-hose
Take out the cap-hose and connect the
outlet-hose.
Be sure to join tightly the drain hose into the
drainoutlet on the back of the machine.
90~100 cm
Drain hose
Hose guide
Be sure to join tightly the drain hose into the
drain-outlet on the side of the machine.
Install the drain hose in the position of about
90~100 cm above the ground. The end of the
drain hose can not be sinked under water.
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle
after the installation is complete.
CALIBRATION MODE
Your Samsung washing machine detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1. Remove laundry or any contents in the machine.
2. Press the Delay End and Spin buttons simultaneously, and then press the Power button. The Machine
turns on with “Cb”
3. Press the Start/Pause button to activate “Calibration Mode”.
4. The drum rotates for approximately 4 minutes.
5. When “Calibration Mode” is fi nished, “End” appears on the display, and the machine automatically
turns off. The washing machine is now ready for use.
installation & maintenance
[W3050_F550]WA80F5G4DJW-03302A_EN.indd Sec5:18[W3050_F550]WA80F5G4DJW-03302A_EN.indd Sec5:18 2013-05-02 4:08:572013-05-02 4:08:57
To Next Page
Loading...
