installation & maintenance_11
installation & maintenance
The User’s Manual is for common use. Make use of the User’s Manual depending upon your washing machine model.
ENVIRONMENT
Leave some space - Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface. - If the washer is placed on an uneven or weak surface, noise or
vibration occurs. (Allowable is 1˚) Adjust the legs for even placement.
Never install the washer near water. - Do not place the washer in steamy rooms or where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters. - As plastic an electrical components are affected by direct heat, never place the
washer near furnaces, boilers, etc. Do not place under direct sunlight.
LEVELLING
If the washer is not leveled with the ground, it makes the machine tremble more or be out of order.
So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF
THE WASHING TUB.
• Open the lid of the machine, pour water into the tub up to the level just
below the pulsator, and adjust the legs so that the pulsator is positioned
at the center of the water as shown in the figure.
• Place the machine more than 10cm away from the wall.
• Adjust the legs on feet for levelling.
CONNECTING THE WATER SUPPLY HOSE
1. Remove the adaptor from the water
supply hose.
4. Connect the water supply hose to the
adaptor. Pull down the part (c) of the
water supply hose. When the part (c)
is released, the hose is automatically
connected to the adaptor making a
‘click’ sound.
2. First, using a “+” type screw driver,
loosen the four screws on the adaptor.
Next, take the adaptor and turn part(b)
following the arrow for gap about 5 mm
between them.
5. Connect the other end of the water
supply hose to the inlet water valve
at the back of the washer. Screw the
hose clockwise all the way in.
3. Connect adaptor to the water tap by
tightening the screws firmly. Then, turn
part(b) following the arrow and put (a)
and (b) together.
5-1. Connect the other end of the water
supply hose to the inlet water valve
at the top of the washer. Screw the
hose clockwise all the way in.
•
If the water tap is a screw type, assemble a water supply hose that fits to the tap as shown.
After completing connection, if water leaks from the hose, then repeat the same steps.
After completing connection, if water leaks from the hose, then repeat the same steps. Use the most
conventional type of faucet for water supply.In case the faucet is square or too big, remove the spacing ring
before inserting the faucet into the adaptor.
ASSEMBLING THE RAT PROTECTION PANEL(OPTION)
Tilt the washer a little and lift up the panel until it
clicks, finally fix the panel with screw to the base
as shown in the figure.
1. Insert the rat protection panel to the
assembling hole on back side to
the end.
2. If you have difficulty inserting the
panel lift up the washer a little and
insert it.
Water
LOOSEN LOCK
a
b
Rear-side
WA80G5PEP-02898E-02_EN.indd 11 2012-12-18 �� 4:46:13
To Next Page
Loading...
