English 23
Installation
C
3. Hold the adaptor and turn part (C) in the
arrow direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap,
and then tighten the screws while lifting
the adaptor.
5. Turn part (C) in the arrow direction to
tighten it.
D
6. While pulling down part (D) on the
water hose, connect the water hose to
the adaptor. Then, release part (D). The
hose ts into the adaptor with a clicking
sound.
7. To complete connecting the water hose,
see 2 and 3 on the “Connecting to a
threaded water tap” section.
NOTE
• After connecting the water hose to the adaptor, check if it is connected properly by
pulling the water hose downwards.
• Use a popular type of water taps. If the tap is square-shaped or too big, remove the
spacer ring before inserting the tap into the adaptor.
WD70M4443JW_03881V-00_EN.indd 23 2020/6/23 10:35:51
To Next Page
Loading...
