Samsung WD70M4 Series - Page 55

English 55
Troubleshooting
Problem Action
HC
High temperature heating check
• If the information code remains, contact a customer service
centre.
1C
The WaterLevel sensor is not working properly.
• Try power off and restarting the cycle.
• Check WaterLevel Sensor wire harness.
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the “1C” code, the washer do
draining for 3 minutes. During this time, the Power button is
inoperative.
8C
The MEMS sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
AC
Check communications between main and sub PBAs.
• Try power off and restarting the cycle.
• If the information code remains, contact a customer service
centre.
AC6
Check communications between main and inverter PBAs.
• Depending on the state, the machine may automatically returns
to normal operation.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
If any information code keeps appearing on the screen, contact a local Samsung service
centre.
WD70M4443JW_03881V-00_EN.indd 55 2020/6/23 10:35:58