Samsung WD80J5 Series - Page 55

English 55
Troubleshooting
Problem Action
LC
Check the drain hose.
• Make sure the end of the drain hose is placed on the oor.
• Make sure the drain hose is not clogged.
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the “LC”/“LC1” code, the washer
do draining for 3 minutes. During this time, the Power
button is inoperative.
LC1
UB
Spinning does not work.
• Make sure laundry is spread out evenly.
• Make sure the washing machine is on a at, stable surface.
• Redistribute the load. If only one item of clothing needs
washing, such as a bathrobe or pair of jeans, the nal spin
result might be unsatisfactory, and an “UB” check message
will be shown in the display.
3C
Check the Motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service
centre.
UC
The electronic control needs to be checked (Over Voltage Error).
• Check the PCB and wire harness.
• Check if power is supplied properly.
• If the information code remains, contact a customer service
centre.
Low voltage detected
• Check if the power cord is plugged in.
• If the information code remains, contact a customer service
centre.
HC
High temperature heating check
• If the information code remains, contact a customer service
centre.
WD80J5410AW_03588H_EN.indd 55 2015/4/9 8:56:25