Water valve connections for the Detergent Drawer
Items Packed With Washer
BOLT-SPANER (10-13mm Wrench) DC60-40146A
ASSY HOSE WATER Cold DC97-15648A
ASSY HOSE WATER Hot DC97-15648B
CAP-FIXER DC67-00307A
HOSE-HANGER DC62-10278A
When using non-HE detergents, or using too much
detergent for the water hardness and soil level of
the clothing, over sudsing will occur. When this
happens there will be leaks out of the detergent
drawer and door. Please advise consumer of
proper detergent usage.
It is normal for some water to remain in Deter-
gent Drawer after it completes washing.
Bleach is usually flushed out into the tub at the
beginning of the washing. Also, its compart-
ment is washed again during the following
rinse cycle, removing any remnants.
NOTICE
The unit sometimes will pause during Sanitize, or Pure Cycle, wash modes and appear not to be functional. The Sani-
tize and Pure Cycle wash cycles have target temperatures to assure washer performance. If the water temperature
doesn't meet the target temperature during the wash cycle, the washer will automatically add extra time to allow the
heater to bring the water up to the programmed, or target temperature. In this stage, the displayed time will pause and
hold until the heating operation has been completed. It is at this point that the customer may feel that operation has
stopped. (The maximum added programmed time is 30 minutes)
To Previous Page
Loading...
