Motor speed sensor problem. Restart the cycle.
If the code reappears, call for service.
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High current detected. Restart the cycle.
If the code reappears, call for service.
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
Too many suds are detected
during the washing session.
The unit is put on hold until the
suds are reduced. Then, the unit
will go back to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
troubleshooting
To Next Page
Loading...
