Samsung WF42H5000AW - Page 24

22 _ Troubleshooting
Error Type
For USA
Causes Remarks
LED LCD
Heater Error
Hr
(Heater
Relay)
- Thewashingheaterisshort-circuitedorhasawire
disconnected.
- Thewashingheaterinthetubhasanerror.(Contact
error,temperaturesensorfault)
- Ifthewaterlevelsensoroperateswithoutwater
becausewaterisfrozenorforanyotherreasonand
thetemperaturesensorengagedatthebottomto
preventoverheatingforthewashingheaterdetectsa
temperatureof100to150˚C,thewashingmachine
turnstheinputpoweroff.
Iftheheaterhas
noerror,this
occursbecause
ofaPBArelay
malfunction.
- Thiserroroccurswhentheredtemperaturesensor
atthecenterofthedryheateroperates(ata
temperaturehigherthan145˚C)
: Correctiveaction–Pressthebuttonatthecenter
lightly.Thewashingmachinewilloperatenormally.
 Alternatively,replacethetemperaturesensorifthe
temperaturesensingisunstablebecauseoffunctional
degradation.
- Thisoccurswhenthesteamfunctiondoesnot
operatenormally.
- Thiserrordoesnotoccurinexistingdrumproducts.
Checkwhethertheproductisasteammodel
Water Leakage
Error
LE
- Heaterengagementfault(outofplace)
- Theairhoseisoutofplaceandwaterleakageoccurs
duringthespincycle.
- Thetubbackatthesafetyboltsxingpartisbroken.
- Waterleakageoccursatthefrontwithfoaming
becauseoftoomuchdetergent
- Waterleakageoccursbecausetheconnectinghose
tothedetergentdrawerisconnectedincorrectly.
- Thedrainpumpltercoverisengagedincorrectly.
- Waterleakageoccursatthedrainhose.
- Theductcondensingholdingscrewsareworn.
- Thenozzle-diaphragmisengagedintheopposite
directionortherubberpackagingisomitted.
- Waterleakageoccursbecausethescrewsthat
holdthetubbackandfrontinplacearefastened
incorrectly.
- Theleakagesensorisfaulty.
OverowError OE
- Waterissuppliedcontinuallybecausethewaterlevel
detectiondoesnotwork.
- Becausethedrainhoseiscloggedandthereis
aninjectionerror(atanarrowsection),thewater
leveldetectiondoesnotworkandwaterissupplied
continually.
- Waterissuppliedcontinuallybecauseoffreezingor
becausethereisforeignmaterialinthewatersupply
valve.
- Thiserrormayoccurwhenthewaterlevelsensoris
degraded.
Thiserroroccurs
becausethe
waterlevel
sensorterminal
isoutofplace.
Temperature
Sensor Error
tE
- Thewashingheaterinthetubhasanerror.(Contact
error,temperaturesensorfault)
- Theconnectorisconnectedincorrectlyoris
disconnected.
- Ifthewaterlevelsensoroperateswithoutwater
becausethewaterisfrozenorforanyotherreason
andthetemperaturesensorengagedatthebottomto
preventoverheatingforthewashingheaterdetectsa
temperatureof100to150˚C,thewashingmachine
turnstheinputpoweroff.
Heatersensor
fault
:Whenthe
connector is
connected
incorrectlyor
hasawire
disconnectedor
contact error