16 English
Installation
Installation
Spanner Bolt caps Hose guide
Cold water hose Hot water hose
(For models with an additional
hot water inlet)
NOTE
• Spanner is needed for adjusting the levelling feet, and removing the shipping bolts on the back of
the washing machine.
• 4 bolt caps are provided for covering the shipping bolt holes.
• Use the hose guide to loop the end of the drain hose.
• Connect the cold and hot water hoses to the inlets at the back of the washing machine to supply
cold and hot water.
• Some models may just have one water supply inlet which is for cold water. If your washing machine
has one water supply inlet, make sure you connect the cold water hose to the cold water tap.
WW3000TM(SEC)_IM_Hongkong_8C104-000991_EN.indd 16 2022-05-02 11:29:39
To Next Page
Loading...
