Samsung WW80T4020EE - User Manual

Questions and Answers

J
Joseph HarperAug 7, 2025
Why does my Samsung WW80T4020EE show an unbalance error?
- A
  Anna HernandezAug 8, 2025
  The unbalance error on your Samsung Washer is caused by the laundry load. Check the laundry to resolve this issue, as this occurs by laundry.
P
Pedro WilliamsAug 13, 2025
Why is there no water supply in my Samsung WW80T4020EE?
- J
  Jonathan DavisAug 13, 2025
  If your Samsung Washer isn't getting water, it could be due to several reasons. Foreign material may be entering the water supply valve, or the water supply valve terminal might not be connected properly. The warm water and rinse connectors could be wrongly connected. Also, check if the PCB terminal from the drain hose to the detergent drawer is not connected, or if the transparent hose is folded or torn. Low water pressure, or a frozen water valve in winter, can also cause this issue. In this case, the water supply valve may be faulty.
T
Todd SteeleAug 17, 2025
Why does my Samsung WW80T4020EE Washer overflow?
- D
  Daniel RodriguezAug 17, 2025
  Your Samsung Washer may be overflowing due to a few potential issues. It could be that water is supplied continually because the water level detection isn't working, possibly due to a clogged drain hose or an injection error. Freezing or foreign material in the water supply valve can also cause continuous water supply. A faulty sensor, or a blocked or damaged pressure tube might also be responsible. All these scenarios can be related to a water level sensor fault.
L
Lindsey MurphyAug 22, 2025
Why is the water level wrong in my Samsung Washer?
- M
  mayersAug 22, 2025
  If the water level in your Samsung Washer is incorrect, it could be due to several reasons. The hose where the water level sensor is located might be damaged, clogged with foreign material, or folded. Too much lubricant on the air hose insertion part, a hose engagement error, a part fault (like faulty internal soldering), a disengaged water level sensor terminal, or a main PBA fault can also cause this. These issues point to a water level sensor fault.
S
stricklandcharlesAug 27, 2025
Why is my Samsung WW80T4020EE heater not working?
- V
  vhaydenAug 28, 2025
  If the heater in your Samsung Washer isn't working, it could be due to a short-circuited washing heater or a disconnected wire. There might be a contact error or temperature sensor fault in the washing heater inside the tub. Also, if the water level sensor operates without water (due to frozen water or another reason) and the temperature sensor detects a high temperature (100 to 150 ?C), the washing machine will turn off the input power. This suggests a heater fault.
C
cmanningSep 1, 2025
What causes communication errors in a Samsung Washer?
- C
  Christian NelsonSep 2, 2025
  Communication errors in your Samsung Washer can occur if the signals between the sub and main PBAs are not sensed. Check the connector connections between the sub and main PBAs carefully and look for any faulty soldering after removing the sub PBA C/Panel. These issues may indicate a Main PCB and Sub PCB Signal Detection fault or a Main PCB and Sub PCB wire connection fault.