Samsung WW8NK52E0VW User Manual

useful tips for your drum washing machine
✔ The descriptions and images in this document may differ from your actual
purchased product. For more information, refer to the user manual.
INSTALLING YOUR WASHING MACHINE
• Installing your washing machine in the location which is slippery
or uneven, will result in vibrations and noise.
• If there is too much noise or vibration, check whether the four
levelling adjustment legs are evenly and firmly on the floor.
• If the washing machine is not level, lift the washing machine
slightly and adjust the lowest of the four levelling adjustment legs.
✔ Before using your washing machine, you must remove the
shipping bolts from the back of the unit.
For more information on removing the safety devices, refer to the user manual.
LEVELLING YOUR WASHING MACHINE WITH THE LEVELLING FEET
✔ Refer to the descriptions appropriate to your washing machine.
1. Level your washer by turning the
adjustable nut in and out, as shown
in the figure.
2. When your washing machine is
level, tighten the locking nut using
the (-) driver.
1. Unfasten the locking
nut by turning it to the
left using a spanner.
2. Level your washing
machine by turning
the adjustable feet in
and out as necessary
by hand.
3. Fasten the locking
nut by turning it to the
right using a spanner.
CLEANING THE FILTER
Cleaning the water supply filter
✔ If the filter net is not installed, it may cause a water leakage and operating error. Make sure to install it.
1. Pull and remove the filter net. 2. Clean the filter. 3. Insert the filter net and fasten
its connector firmly.
Cleaning the debris filter
✔ When water does not drain well or ‘5E’ blinks on the display, clean the debris filter. The product appearance
may differ from your washing machine. (However, the cleaning descriptions are the same.)
1. Open the filter
cover using a coin
or a key.
4. Unscrew the
emergency drain
cap by turning it
counter clockwise.
2. Unscrew the
emergency drain
cap and pull out the
emergency drain
tube to drain off the
remaining water.
5. Clean the debris
filter and the inside
of the drain hose.
3. Hold the cap on
the end of the
emergency drain
tube and allow all
the water to flow
into a bowl.
6. Replace the
debris filter, the
emergency drain
cap and tube and
then close the filter
cover.
✔ If you open the debris filter when water remains inside the tub, water may flow out.
✔ If the debris filter is assembled incorrectly or not installed, it may cause a water leakage or operating error.
Therefore make sure to assemble it correctly.
MAKE SURE YOU KNOW...
Adding the
laundry
• Adding laundry
➲ Press the Add laundry(Stop&Add) button and add the laundry when the Add
laundry lamp turns on.
• If you add the laundry during a spin cycle, it starts again with the initial set time
regardless of the remaining time.
Washing
bedding
• Wash bedding using only the Bedding course.
➲ You can wash acrylic, mixed spinning and woolen bedding.
➲ When washing general clothes, the washing machine may
not operate in the optimal status.
• Wash only one bedding item at a time regardless of size.
➲ Insert bedding rolled up into a ball.
The center of gravity is distributed evenly causing less
vibrations and noise.
✔ Do not wash electric blankets or carpets.
✔ When spinning blankets, cotton bedding, and woolen bedding,
too much noise and vibrations may occur and the wash cannot
be completed as spinning is not performed.
Locking nut
Adjustable nut
Spanner
(-) Driver
Nut
Adjustable feet
Spanner
Inside
Debris
filter
Wash
individually.
Make sure that the leveling feet
legs are level with the floor.
DC68-02209B_EN_DE_FR_ES_IT_PT_RU.indd 1 2008-03-19 ¿ÀÈÄ 3:03:50
Questo manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per Samsung Lavatrice
WW8NK52E0VW o cerca il tuo prodotto tra le migliori offerte di Lavatrici e Asciugatrici

Samsung WW8NK52E0VW Specifications

General

Door color	Black
Door hinge	Left
Control type	Rotary
Display type	LED
Loading type	Front-load
Product color	White
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Freestanding
Lower built-in capability (topless)	No
Drum capacity	8 kg
Spin-drying class	B
Maximum spin speed	1200 RPM
Minimum spin speed	400 RPM
Noise level (spin)	72 dB
Noise level (wash)	56 dB
Energy efficiency scale	A to G
Water consumption per cycle	48 L
Energy consumption washing per cycle	- kWh

Weight and Dimensions

Depth	456 mm
Width	600 mm
Height	850 mm
Weight	67000 g

Summary

Installing Your Washing Machine

Levelling Your Washing Machine with the Levelling Feet

Guides on how to level the washing machine using adjustable feet for stability and reduced vibration.

Cleaning the Filter

Cleaning the water supply filter

Instructions for cleaning the filter net in the water supply hose to prevent leaks and errors.

Cleaning the debris filter

Steps to clean the debris filter and drain tube when water doesn't drain or '5E' error occurs.

Make Sure You Know...

Adding the laundry

Details on how to add laundry during the cycle using the Add laundry button when the lamp is on.

Washing bedding

Guidance on washing bedding using the Bedding course, including item limits and handling.

Try the Following...

When the door does not open

Explains why the door may not open (high temperature, water inside) and how to resolve it.

When selecting the Dry function

Provides advice on drying capacity, performance decrease with overloading, and optimal drying.

When inserting fabric softener

Guides on correct fabric softener insertion to prevent overflow and issues with the rinse cap.

When the wash time increases

Explains why wash time increases (unbalance) and how to re-balance the load.

Self-Test Error Codes

DE Error

Addresses the 'DE' error, indicating an issue with the door not being closed properly.

4E Error

Troubleshoots the '4E' error related to water supply issues or blocked filters.

5E Error

Resolves the '5E' error indicating a problem with water drainage or a blocked drain filter.

HBE Error

Explains the 'HBE' error, relating to high drum temperature after drying or air wash cycles.

CE Error

Addresses the 'CE' error where water does not drain due to high internal temperature.