Why is water not being supplied to my Samsung WW8*J3 Washer?
If water isn't being supplied to your Samsung Washer, check that the water taps are open and the hoses aren't clogged or frozen. Ensure sufficient water pressure and proper connection of the hot and cold water taps. Also, clean the mesh filter, as it may be clogged.
Why are no bubbles seen in my Samsung WW8*J3 Washer?
The absence of bubbles in your Samsung Washer may be due to overloading or severely contaminated laundry.
Why can't I add more detergent to my Samsung WW8*J3 Washer?
Make sure the remaining amount of detergent and fabric softener is not over the limit in your Samsung Washer.
Why does my Samsung WW8*J3 Washer have odours?
Odors in your Samsung Washer may be due to excessive suds collecting in recesses. Run cleansing cycles periodically to sanitize, clean the door seal, and dry the interior after each cycle.
Why does my Samsung WW8*J3 Washer fill with the wrong water temperature?
If your Samsung Washer fills with the wrong water temperature, fully open both taps and ensure the temperature selection is correct. Verify hoses are connected to the correct taps and the water heater is set to at least 120 °F (49 °C). Disconnect the hoses and clean the mesh filter. The water temperature may fluctuate initially as the automatic temperature control adjusts.
Why does my Samsung WW8*J3 Washer keep stopping?
If your Samsung Washer stops mid-cycle, ensure it's plugged into a live outlet and check the fuse or circuit breaker. Close the door and press Start/Pause. Note that some cycles have pause or soak periods. Also, ensure the water supply hose mesh filter isn't clogged. Insufficient power can also cause temporary stops.
Why does detergent remain in the detergent drawer of my Samsung WW8*J3 Washer after a cycle?
If detergent remains in the drawer of your Samsung Washer after a cycle, ensure the machine runs with sufficient water pressure and that detergent is added to the drawer's center. Check the rinse cap is properly inserted. If using granular detergent, ensure the selector is in the upper position. Consider removing the rinse cap and cleaning the drawer.
How to reduce excessive suds in my Samsung WW8*J3?
To address excessive suds in your Samsung Washer, use the recommended type of detergent, specifically a high-efficiency (HE) detergent. Reduce the detergent amount for soft water, small loads, or lightly soiled loads. Non-HE detergents are not recommended.
Why is my laundry load still wet after a Samsung WW8*J3 cycle?
If your laundry load is still wet after a cycle in your Samsung Washer, use the High or Extra High spin speed. Use high-efficiency (HE) detergent to reduce oversudsing. Be aware that small loads can become unbalanced and not spin completely. Also, check the drain hose for kinks or clogs.
How to fix a Samsung Washer that does not start?
If your Samsung Washer doesn't start, ensure it's properly plugged in, the door is fully closed, and the water taps are open. Press the Start/Pause button, and confirm Child Lock is off. Also, check the fuse or reset the circuit breaker.
To Next Page
General