English 23
2. Use a Phillips screwdriver to loosen four screws on
the adaptor.
3. Hold the adaptor and turn part (C) in the arrow
direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap, and then
tighten the screws while lifting the adaptor.
5. Turn part (C) in the arrow direction to tighten it.
6. While pulling down part (D) on the water hose,
connect the water hose to the adaptor. Then,
release part (D). The hose fits into the adaptor with
a clicking sound.
7. To complete connecting the water hose, see 2 and
3 on the “Connecting to a threaded water tap”
section.
Untitled-2 23 2024-03-11() 3:00:40
To Next Page
Loading...
