San Jamar EZ-Fit User Manual

C2210C EZ-FIT
®
EURO CUP DISPENSER INSTALLATION INSTRUCTIONS
4 7/8” Dia.
124 mm
HOLE SAW RECOMMENDED
1. CUT HOLE IN COUNTER SURFACE
2. REMOVE TRIM RING TURNING
COUNTER CLOCKWISE
3. SECURE CUP DISPENSER TO COUNTER
WITH SUPPLIED SCREWS (#8 SCREWS)
4. SELECT PROPER SIZE GASKET FOR CUP
(SEE TABLE ON BACK)
5. INSTALL GASKET OVER POSTS IN
UNDERSIDE OF RING
6. REPLACE COVER RING WITH GASKET BY TURNING
CLOCKWISE OVER MOUNTING RING UNTIL SECURE
7. LOAD CUPS THROUGH GASKET
REPLACEMENT PARTS & ACCESSORIES
(see reverse side for replacement gaskets)
X22MT Black Mounting Ring (new low profile)
X22TR Black Trim Ring (new low profile)
C2215 Spring
C2203BK End Cap
C3426BK Cup Pusher
C2202SV Wire Cage for Surface Mount
C22XC Chrome Trim Ring

San Jamar EZ-Fit Specifications

General

Brand	San Jamar
Model	EZ-Fit
Category	Dispenser
Language	English

Summary

Installation Instructions

Cut Hole in Counter Surface

Cut a 4 7/8" (124 mm) diameter hole in the counter surface using a hole saw.

Remove Trim Ring

Turn the trim ring counter-clockwise to remove it from the dispenser.

Secure Dispenser to Counter

Fasten the cup dispenser to the counter using the supplied #8 screws.

Select Proper Gasket for Cup

Choose the correct gasket size for your cup, referring to the table on the back page.

Install Gasket Over Posts

Place the selected gasket over the posts located on the underside of the mounting ring.

Replace Cover Ring with Gasket

Turn the cover ring clockwise over the mounting ring until it is securely fastened.

Load Cups Through Gasket

Insert cups into the dispenser by pushing them through the installed gasket.

Replacement Parts and Accessories

Gasket Sizing Guide

Measure Cup Rim Diameter

Turn cup upside down on a ruler and align the widest point of the rim with the ruler's end.

Determine Gasket Size

Identify the cup's gasket size (Small, Medium, Large, Extra Large) based on rim diameter.

Use Correct Gasket

Select and use the gasket that matches the determined cup rim size for proper fit.