San Jamar Tear-N-Dry Essence User Manual

MOUNTING INSTRUCTIONS (Dispenser must be mounted level)
The user is responsible for the proper installation and use of this dispenser.
Equipment needed:
Measuring tape
Level
Screwdriver
Eye protection
Pencil
Drill and drill bit
Assemble appropriate fasteners (screws, bolts, anchors, washers, etc.) for mounting.
1. Determine position on wall/surface with unit open. Through the holes at the back of the unit, use pencil to mark the spots where
the drilling will be necessary. Be sure unit is level before marking holes. WARNING: Proper function of this dispenser
requires level mounting. Try to mark spots as close as possible to the outer edges.
2. Drill the marked spots on the wall/surface with appropriate sized drill bit suitable for the wall material and fasteners used.
3. Complete the installation. Be sure to use fasteners (and anchors) in all mounting holes that are appropriate for the wall/surface to
which the dispenser will be mounted. The installation should be done with a flat washer between the head of the fastener and the
inside back of the dispenser.
The Tear-N-Dry Essence is powered by 4 D-cell alkaline batteries. Take care to load batteries in correct orientation as shown on the
battery compartment inside door. After inserting batteries wait 5 seconds before closing cover. If the batteries are loaded incorrectly,
the Tear-N-Dry Essence will not function. A flashing red indicator light indicates that batteries need to be replaced.
!
WARNING:
Do not use rechargeable or NiCad batteries as these may cause damage to your dispenser or personal injury.
Tear-N-Dry Essence
TOUCHLESS TOWEL DISPENSERS INSTRUCTIONS
Take care to load batteries in correct orientation, with positive end of battery towards the left as you are facing the dispenser.
(Tenga cuidado al instalar las baterías, oriéntelas con el lado positivo hacia su izquierda cuando este de frente al dispensador).
Note: If batteries are loaded incorrectly, the unit will not function. (Nota: Si las baterías son instaladas incorrectamente, el unidad no funcionará.)
Rechargeable
Recargables
NiCad
BATTERY LOADING:

San Jamar Tear-N-Dry Essence Specifications

General

Brand	San Jamar
Model	Tear-N-Dry Essence
Category	Dispenser
Language	English

Summary

Mounting Instructions

Mounting Equipment and Preparation

Lists necessary tools and materials for dispenser installation, including fasteners and safety gear.

Installation Procedure

Outlines the steps for marking, drilling, and securely mounting the dispenser using appropriate fasteners and washers.

Level Mounting Mandate

Stresses that dispenser function depends on precise level mounting to avoid operational issues.

Battery Loading

Battery Installation and Orientation

Details the correct insertion of 4 D-cell batteries, emphasizing positive terminal placement and post-insertion wait time.

Battery Type Warning

Warns against using rechargeable or NiCad batteries, citing risks of dispenser damage and personal injury.

Paper Loading

Loading Procedure

Step-by-step guide for opening the cover, loading paper onto hubs, and preparing the dispenser for use.

Dispenser Operation and Troubleshooting

Initial Use

Instructions for operating the dispenser after loading paper and supplying power, including how it dispenses a towel.

Troubleshooting Common Issues

Guidance on resolving typical dispenser problems by manipulating the cover or reinserting/replacing batteries.

Available Accessories

Replacement Covers

Lists available replacement covers for Classic and Oceans dispenser models, with color options.

Replacement Parts

Identifies other available parts such as replacement keys and lock fingers for dispenser maintenance.