S&C 2020 - Page 6

6 S&C Instruction Sheet 716-504
Reorder Information for Safety Labels
Location Safety Alert Message Description Number
A
CAUTION
Transition box contains a stop bracket and spacer...
G-5807
B
CAUTION
Remove the interrupter operating-rod holding bracket and
spacer...
G-5951
C Instruction
Connecting-Pin Installation G-5685
D Instruction
Attaching Operator Connecting Link
G-5792

E Instruction
Instructions-Operation, Gas Pressure Indicator, and Manual
Handle
G-5670

F
CAUTION
"C"–Shaped Clevis at lower end... G-6082
G Instruction
Access Shutter G-5675
H
CAUTION
Control Voltage
48 Vdc G-5948-1
125 Vdc G-5948-2
115 V 60 Hz G-5948-3
J Instruction
Fuse Slugs
G-5939

K
CAUTION
Do not apply control voltage or insert motor-and-closing circuit
fuseholder.
G-5959▲
L
CAUTION
Do not apply control voltage to this device...
G-5947▲
M
CAUTION
Do not attempt to close Circuit-Switcher using manual trip lever... G-6222
N Instruction
Coupling Preparation
G-5684

P
WARNING
Do not lift switch with this bracket...
G-5713▲
Q
WARNING
Do not remove steel over wrapper until installation is complete...
G-5699▲
R
WARNING
Do not remove...
G-5993▲
S
CAUTION
Connect the interphase locking rod...
G-5949
T
CAUTION
Connect the interphase operating rod...
G-5950

This is a tag that is to be removed and discarded after the switch is installed and adjusted.
 This label contains important instructions and should be promptly replaced if illegible or missing.
▲ This label is affixed to the shipping package and will be removed and discarded after the switch is installed and adjusted.
Safety Information