S&C 6801 - User Manual

Setup
Table of Contents
Section Page Section Page
Introduction
Qualified Persons .......................... 2
Read this Instruction Sheet ................... 2
Retain this Instruction Sheet. . . . . . . . . . . . . . . . . . . 2
Special Warranty Provisions ................... 2
Safety Information
Understanding Safety-Alert Messages ........... 4
Following Safety Instructions .................. 4
Replacement Instructions and Labels ........... 4
Safety Precautions ...........................5
IntelliLink® Setup Software
Applicable Software ......................... 6
Software Overview .......................... 7
Computer Requirements ..................... 7
IntelliLink® Setup Software License Activation .... 8
Installing a License Activation File . . . . . . . . . . . . . . 9
Starting IntelliLink Software ...................11
Navigating IntelliLink Screens .................11
IntelliLink Workspace ........................16
Switch Control Setup
Setup General Screen ...................... 20
Sensor Configuration ....................... 22
Site-Related Configuration ................... 25
Metering Data ............................. 28
Fault Detection Configuration ................ 29
Automatic Operation Configuration ...............37
User Commands Configuration ............... 44
Hot Line Tag .............................. 45
Shots to Lockout ........................... 45
Time Configuration ........................ 46
Firmware Revisions ........................ 49
User Notes ............................... 49
Team RTU Addresses ...................... 50
Team Setup ...............................51
External Loading ........................... 56
Team Communication Parameters ............ 58
Distributed Generation ...................... 59
Restoration—External Device .................61
Communications Setup ..................... 64
Serial Ports ............................... 70
Routing ..................................71
Ethernet Settings .......................... 72
Wi-Fi Settings ..............................74
Communication Tests ....................... 75
DNP Diagnostics .......................... 77
DNP Status Point Mapping .................. 78
DNP Double-Bit Status Point Mapping ......... 80
DNP Analog Input Point Mapping ...............81
DNP Control Point Mapping .................. 82
DNP Analog Output Point Mapping ............ 83
DNP Counter Point Mapping ................. 84
Security Settings .......................... 85
Log Management .......................... 86
Setup Validate/Apply ........................ 89
January 28, 2019
© S&C Electric Company 2011-2019, all rights reserved
Instruction Sheet 1045-530
S&C 6800 Series Automatic Switch Controls with
IntelliTeam
®
SG Automatic Restoration System

Summary

Introduction

Qualified Persons

Defines qualification for equipment installation, operation, and maintenance.

Safety Information

Understanding Safety-Alert Messages

Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE signals used throughout the document.

Safety Precautions

QUALIFIED PERSONS

Restricts access to the switch control to qualified persons only.

SAFETY PROCEDURES

Stresses the importance of always following safe operating procedures and rules.

PERSONAL PROTECTIVE EQUIPMENT

Lists essential protective equipment required for safe operation.

IntelliLink Setup Software - Core Setup

Computer Requirements

Details the hardware and software prerequisites for installing the IntelliLink Setup Software.

Installing a License Activation File

Provides step-by-step instructions to install a license activation file.

IntelliLink Setup Software - Operation and Navigation

Starting IntelliLink Software

Provides step-by-step instructions to launch and start the IntelliLink Setup Software.

Switch Control Setup - General Configuration

Setup General Screen

Sensor Configuration

Site-Related Configuration

Switch Control Setup - Fault Detection and Automation

Fault Detection Configuration

Automatic Operation Configuration

Switch Control Setup - Advanced Configuration

User Commands Configuration

Time Configuration

Switch Control Setup - IntelliTeam SG Configuration

Team RTU Addresses

Team Setup

Switch Control Setup - Communications and Security

Team Communication Parameters

Communications Setup

Security Settings

Switch Control Setup - Logging and Validation

Log Management

Setup Validate;Apply

S&C 6801 Specifications

General

Brand	S&C
Model	6801
Category	Controller
Language	English