To Next PageTo Next Page
Need help?Do you have a question about the S&C IntelliCap 2000 and is the answer not in the manual?
General| Brand | S&C |
|---|---|
| Model | IntelliCap 2000 |
| Category | Controller |
| Language | English |
Defines who is qualified to install, operate, and maintain the IntelliCap 2000 control.
Emphasizes the importance of thoroughly reading this instruction sheet and related materials.
Instructs users to keep this instruction sheet as a permanent part of the control.
Stresses selecting the equipment for a specific application within its rated limits.
Outlines the standard warranty terms and conditions for the IntelliCap 2000 control.
Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE messages.
Advises contacting S&C for assistance if any part of the sheet is unclear.
Guides on obtaining additional copies of the instruction sheet and replacing labels.
Restricts access to the IntelliCap 2000 control solely to qualified personnel.
Mandates following all safe operating procedures and company rules.
Stresses the use of appropriate PPE like gloves, hard hats, and safety glasses.
Instructs users not to remove or obscure safety labels on the equipment.
Emphasizes maintaining proper clearance from energized components during work.
Details the required IntelliCap 2000 software version and system prerequisites.
Provides a step-by-step checklist for inspecting the control and verifying setup requirements.
Describes optional configuration steps that can be performed before on-site installation.
Details how to correctly wire and mount the control on a meter base.
Explains mounting the control to a pole using straps or bolts.
Guides on connecting the wiring harness for current and neutral sensing.
Details how to connect and configure external voltage sensing options.
Describes neutral current and neutral voltage sensing installations.
Steps for putting the installed control into service and verifying its functions.
Instructions for connecting communication equipment like radios or Ethernet.
Cautionary advice on avoiding crimping the ribbon cable when removing/reinstalling the front panel.
Provides the standard wiring diagram for the IntelliCap 2000 control.
Illustrates wiring for optional communication and sensor modules.
Details wiring configurations for 4-jaw meterbase options (40, 41, 42).
Provides wiring details for various 6-jaw meterbase options (60-68).
Shows wiring configurations for K1 and M1 option modules.
Illustrates wiring for M3 and M5 option modules.
Details wiring configurations for M7 and M11 option modules.
