Introduction
Qualified Persons
WARNING
Only qualified persons who are knowledgeable in the installation, operation, and
maintenance of overhead and underground electric distribution equipment, along
with all associated hazards, may install, operate, and maintain the equipment
covered by this publication. A qualified person is someone who is trained and
competent in:
• The skills and techniques necessary to distinguish exposed live parts from nonlive
parts of electrical equipment
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
• The proper use of special precautionary techniques, personal protective
equipment, insulated and shielding materials, and insulated tools for working on
or near exposed energized parts of electrical equipment
These instructions are intended ONLY for such qualified persons. They are
not intended to be a substitute for adequate training and experience in safety
procedures for this type of equipment.
Read this
Instruction Sheet
NOTICE
Thoroughly and carefully read this instruction sheet and all materials included in
the product’s instruction handbook before installing or operating the IntelliCap 2000
Automatic Capacitor Control. Familiarize yourself with the Safety Information and
Safety Precautions on pages 4 through 5. The latest version of this publication is
available online in PDF format at sandc.com/en/support/product-literature/.
Retain this
Instruction Sheet
This instruction sheet is a permanent part of the IntelliCap 2000 Automatic Capacitor
Control. Designate a location where you can easily retrieve and refer to this publication.
Proper Application
WARNING
The equipment in this publication must be selected for a specific application. The
application must be within the ratings furnished for the selected equipment. Ratings
are listed in S&C Specification Bulletin 1024-31.
2 S&C Instruction Sheet 1024-510
To Next Page
Loading...
Need help?
General
