jurisdiction and venue of such courts. You will not remove or export from the
United States or re-export from anywhere any part of the Software or any direct
product thereof to any country in violation of U.S. Export Administration
Regulations, or a successor thereto, except in compliance with and with all licenses
and approvals required under applicable export laws and regulations including,
without limitation, those of the U.S. Department of Commerce. Any waivers or
amendments of this Agreement shall be effective only if made in writing and signed
by an authorized representative of each party. You agree that the Licensors are
third party beneficiaries of this Agreement to enforce your performance of the
terms and conditions of this Agreement. The provisions of Sections 2, 3, 4, 5, 6, 7,
8 and 9 shall survive the termination or expiration of this Agreement.
FCC Regulation
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and then on, the user is encouraged to
try to correct the interference by one or more of the following measures:
1) Increase the separation between the equipment and receiver.
2) Correct the equipment to a different outlet so that the equipment and receiver
are on different branch circuits.
3) Consult the dealer or an experienced radio / TV technician for help.
To Previous Page
Loading...
