To Next PageTo Next PageWhat to do if Saneo Air Conditioner won't turn on?
Your Saneo Air Conditioner might not turn on for a few reasons. First, check if the ‘full tank’ indicator light is blinking, which means the water tank is full and needs emptying. Also, if you are in heating mode, the room temperature may be higher than the set temperature; in cooling mode, the room temperature may be lower than the set temperature. In either case, try resetting the temperature.
Why Saneo Air Conditioner room does not cool down enough?
If your Saneo Air Conditioner isn't cooling the room sufficiently, several factors could be at play. Ensure that all doors and windows are closed to prevent warm air from entering. Identify and remove any sources of heat in the room, or switch them off. Check that the exhaust pipe is properly connected and not blocked; connect or clean it as necessary. Also, make sure the set temperature isn't too high and reset it to a cooler setting. Finally, verify that the air inlet isn't blocked and clean it if needed.
What does E2/E4 code mean on Saneo Air Conditioner?
The E2/E4 code on your Saneo Air Conditioner indicates that the water tank is full. To resolve this, simply empty the water tank.
What does E0 code mean on Saneo Air Conditioner?
The E0 code on your Saneo Air Conditioner indicates that the room temperature sensor is not working. You can replace the room temperature sensor. Note that the appliance will still function without the sensor.
General| Brand | Saneo |
|---|---|
| Model | A010A-12C |
| Category | Air Conditioner |
| Language | English |
