Sangamo Choice RSTAT5 RF

To Next Page

Choice RSTAT5 RF

Wireless Digital Programmable Thermostat

User Instructions

A programmable thermostat differs from a programmer that you may be used to.

With this thermostat you do not set on and off times. Instead you are setting your

desired temperature at varying points throughout the day. This means your home

will always be comfortably warm when needed but you will not be wasting energy

(and money) heating your home when it’s not required.

If your thermostat is set to 21°C, for example, your boiler will run until the

thermostat reads over that temperature and then tell the boiler to turn off,

meaning you won’t be calling for heat when your home is already at your desired

temperature.

When you set a temperature you are saying you don’t want the heating to come on

unless the room temperature is lower than the set temperature.

WHAT IS A PROGRAMMABLE THERMOSTAT?

The Choice RSTAT5 RF comprises of a portable battery powered thermostat

(transmitter) and a separate wall mounted mains relay box (receiver). The

transmitter should be located in the main living area and the receiver is mounted

close to the boiler.

This programmable room thermostat has been designed to bring you comfort and

energy economy. It allows you to program and regulate your heating system using

up to 6 programmable events per day.

To ensure its correct operation the thermostat should be mounted or situated

approximately 1.3m above the oor and away from direct sunlight, heat sources and

drafts.

INTRODUCTION

Main Page

Other manuals for Sangamo Choice RSTAT5 RF

Installation Instructions4 pages

Need help?

Do you have a question about the Sangamo Choice RSTAT5 RF and is the answer not in the manual?

Summary

What is a Programmable Thermostat?

Introduction

Setting the Time and Date

What is Switching Differential?

Explains the function of switching differential for boiler operation and temperature maintenance.

Default Program

Custom Program

Creating Your Program

Programming

Copy;Paste Day

Explains how to copy programming settings from one day to another to simplify setup.

Reset Unit

Details the procedure to restore the thermostat to its factory default settings and programs.

Change the Temperature

Change the Temperature for a Set Number of Hours

Describes how to temporarily override the schedule to hold a specific temperature for a defined period.

Hold Temperature Permanently

Holiday Mode

Explains how to set a desired temperature that will be maintained until a specific future date.

Changing the Batteries

Receiver

Service and Warranty

Customer Care Policy