Need help?Do you have a question about the Sanken NS-4A006-B and is the answer not in the manual?
Specifications for control terminal wire size and tightening torque.
Important notes on voltage input and cable placement for noise.
Identifies and describes the inverter's panel controls and displays.
Explanation of data shown on primary and secondary LCD screens.
Table of monitored parameters, units, and LCD display content.
Options for selecting motor control mode (V/f, Speed Control).
Configures the type of braking to be used.
Limits output current during constant speed operation.
Sets overload alarm thresholds based on operating mode.
Specifies the type of motor connected to the inverter.
Sets voltage drop percentage for simple energy-saving.
Selects the source for PID1 command value input.
Sets the proportional gain for PID controller 1.
Sets the integral time for PID controller 1.
Selects the source for PID2 command value input.
Sets the proportional gain for PID controller 2.
Selects the PID control action type (Open loop, PID1, etc.).
Inputs for motor poles, rated voltage, and capacity.
Sets the torque limit during power running.
Selects energy-saving mode: V/f or Auto.
To Next Page
General
