SANLI SLB260 - Starting the Sanli Blower; Blower Vac

8 Sanli Blower / Blower Vac User Guide
Mix 25 parts of 95 octane regular
unleaded petrol to 1 part 2-stroke oil
(25:1).Donotoverllthetankasthiscan
risk fuel spilling on hot parts when in use.
Press primer bulb three or four times until
a ow of fuel is visible inside the fuel line
see(Figure 6).
Slide the ignition switch back from the
STOPposition(Figure 7).
Set choke lever into closed position if
starting from cold (Figure 8).
Pull the starter cord until the Blower /
BlowerVacstarts(orsoundslikeitwants
tostart)thenreturnchoketoopen
position.
After it starts, allow the engine to warm up
foratleast20to30seconds.
For warm restarts, do not prime, just pull
the cord and it will start after one or more
pulls.
To stop the engine, simply slide the
ignition switch forward to the STOP
position (Figure 9).
Figure 7.
Figure 8.
Figure 9.
Figure 6.
Starting your Blower /
Blower Vac.
STOP
ON